Graco Fusion AP #53 Cleanout Drill Bit Kit

Product Overview

Graco's Fusion AP spray guns rely on a precisely sized impingement port to mix and dispense polyurea, polyurethane foam, and coating materials. Over repeated use, cured material can build up inside that port and restrict flow, throw off the mix ratio, or cause the gun to underperform. The 246627 Cleanout Tool Repair Kit is Graco's factory-matched maintenance solution for that wear point.

The kit is built around a #53 gauge cleanout (drill) bit, the size used to clear the impingement port on Fusion AP guns that call for a #53 tip. Running the bit through the port by hand clears out dried or cured material and restores the port to its original diameter, helping the gun maintain accurate proportioning and consistent spray output.

Key benefits:

• Genuine Graco part, sized to match the Fusion AP gun's #53 impingement port for a precise fit
• Restores proper material flow and mix ratio by clearing cured buildup from the gun's mix chamber
• Simple, low-cost routine maintenance that a contractor can perform on the jobsite without downtime for a repair shop visit
• Compact, lightweight tool that's easy to keep in a truck or gun case for regular upkeep

Best for: spray foam insulation and polyurea coating contractors running Graco Fusion AP guns who need to keep their #53 impingement port clear as part of regular gun maintenance.

The Graco 246627 #53 Cleanout Drill Bit Tool Kit is used for maintaining Graco's Fusion Air-Purge (AP) Spray Guns.

• Height: 0.45 inches
• Length: 0.4 inches
• Width: 3.25 inches