GMX Ultra Shield 55G WB Waterproofing Membranes Black

Ultra-Shield WB Waterproofing is a polymer-modified asphalt emulsion membrane designed and recommended for use as the membrane component in an exterior wall waterproofing system. Ultra-Shield WB forms a tough, durable membrane that bridges shrinkage cracks and maintains its superior performance properties when exposed to the chemicals found in soil. Ultra-Shield WB meets the ICC ESR acceptance criteria for cold, liquid-applied below-grade exterior waterproofing materials.

Ultra-Shield WB is compatible with a wide range of insulation, drainage and protection products. Your applicator can design the waterproofing solutions best suited to each project’s specific application requirements and budgetary constraints. Storage and Handling Considerations: Store materials in a dry area and protect from direct sunlight. Ideally, the materials should be stored inside in a temperature controlled environment (interior temperatures between 60–80°F). Do not allow Ultra-Shield WB to freeze. Any materials exposed to the elements should be elevated above the ground and covered by a tarpaulin. Materials should not be exposed to excessive heat or direct flame.

• Elongate up to 2000%
• Bridge shrinkage cracks (up to 1/16 inch)
• Control water migration between the coating and application surface (localize leaks)
• Impede water at high heads due to improved water vapor permeance
• Comply with EPA Model Standard for radon control in new home construction
• Self-heal

• Color: Black
• Solids: 62% +/- 5 (by weight)
• Density: 8.4 lbs./gal (1.0 g/cu. cm)
• Application: Airless Spray, Brush, Roller
• Cure Time: 2 – 24 hours
• Hydrostatic Pressure: Meets AC 29 requirement over Cracks (ASTM C 1306) for pressure resistance
• Low-Temperature Flexibility: Meets AC 29 requirement. (ASTM C 836 @ - 26 C.) No cracking or loss of and Crack Bridging adhesion
• Adhesion Strength to Poured Cement: ASTM C 836, 2.469 lbf/in Meets AC 29 requirement. Section 6.10
• Adhesion Strength to Unparged Masonry: 1.855 lbf/in. Meets AC 29 requirement. ASTM C 836, Section 6.10
• Resistance to Water: No blistering or (ASTM D 2939, Section 15) re-emulsification. Meets AC 29 requirement
• Remains in Place During Application: Meets AC 29 requirement
• Water Vapor Permeance: .29 perms ASTM E 96, Water Method
• Extensibility after Heat Aging: 1/4 inch No Cracking (ASTM C 836, Section 6.12) Meets AC 29 requirement
• Elongation: 1936% min. (ASTM D 412, die c) Cure Time 12 – 24 hours