Hohmann & Barnard 14 gauge 1 inch Hot-Dipped Galvanized Adjustable Veneer Anchor

The HB-213 is an adjustable veneer anchor for metal stud and wood stud construction.

The compressed leg 2X-HOOK has been tested and designed to withstand over 200-lbf, in tension or compression, at maximum allowed offset (ACI 530 6.2.2.5.5.4) of 1-1/4 inches (disengagement of the pintle from the veneer anchor). These results exceed BIA recommendations and the capabilities of standard "round wire" hooks or pintles by over 100%.

• The L-shaped plate section has numerous ribs for added strength and 9/32 inches holes for connecting screws
• The eyelets allow 2X-HOOK (pintle) insertion (1-1/4 inches maximum allowable eccentricity) and are sized to prevent in-and-out movement beyond allowable tolerances
• For concrete, CMU or brick backup, use the HB-5213.

• 2X-HOOK can be installed with legs pointing up or down
• The embedded portion of the 2X-Hook is 3/16 inches DIA round wire, satisfying the code requirement that the mortar bed thickness (typically 3/8 inches) must be twice the diameter of the wire
• 2X-HOOK: U.S. Pat. No. 8,613,175
• H&B recommends 16 inches x 16 inches spacing
• Legs fabricated to accommodate up to 6 inches thick insulation and/or wallboard combination (state thickness when ordering)

• Vertical Adjustability: 1-1/4 inches
• Finish: Hot-Dip Galvanized
• Hole Diameter: 9/32 inches
• Thickness/Gauge: 12 gauge,14 gauge
• Backup Type: Brick, Concrete, CMU, Metal Stud,Wood Stud
• Minimum Air Space Requirement: 3/4 inches