SWD Urethane Quik-Shield YETI Hydrofluoro-Olefin 2.0 lbs Closed Cell B Side

Quik-Shield YETI is a closed-cell spray foam insulation, using Honeywell’s Solstice liquid blowing agent which has a GWP of 1, 99.9% lower than traditional blowing agents meeting GWP initiatives. It is a high-performance insulation and air barrier, ideal for residential and commercial construction. Quik-Shield YETI increases jobsite efficiency, decreases labor and overhead costs, and delivers a lower install cost.

• 2.0 lb/ft3 density
• Average 4,800 bd.ft.
• R-Value 7.5 at 1 inch
• Renewable/recycled content
• GREENGUARD Gold certified
• Leed - Quik-Shield YETI has a minimum of 10.5% total renewable/recycle content, 5.5% pre-consumer recycled, 4.2% post-consumer recycled, 2.0% rapidly renewable, and IEQ Credit- low emitting

• Specific Gravity: 1.21
• Viscosity (cPs): 550±100

• Do not spray foam when substrate surface temperatures are less than 5°F above the dew point
• Clean surfaces according to "Preparation of Substrates" section
• If priming, follow manufacturer recommendations. Ensure primer is adequately cured prior to application
• Substrate temperatures should be between 20-120°F (-6-49°C) flashing is recommended at lower temperatures
• Flush an adequate amount of material through the lines/gun prior to spraying desired surface when changing between systems. Flush amount will be dependent on prior system used
• Do not recirculate
• Quik-Shield YETI shall not exceed 4 inches per lift, with a minimum 20-30 minute wait time between lifts
• Before application, test material to ensure that material sprays, cures, and hardens properly
• Inspect applied material intermittently to ensure no problems exist. If problems are detected, discontinue application and inspect all substrates, equipment, gun, and liquid material for problem source(s)