GSP SurfaLube 1 gal Equipment Storage Fluid D-W400590-J

SurfaLube Equipment Storage Fluid is used in Urethane Dispensing and Polyurea Spray Equipment for mid to long-term storage (up to 36 months). SurfaLube is a plasticizer that prevents Isocyanate Polymers from forming crystals. It makes polymers flexible and soft and is designed to avoid forming Isocyanate (A) crystals inside transfer pumps, hoses, proportioners, and guns. It is ideal for winterizing your rigs and can withstand severe cold environments without freezing (the freezing point is -70 °C (-94 °F)). SurfaLube Eco-Friendly Ingredients are formulated to keep the ISO (A) line or Resin (B) line from hardening. However, there may be a reaction if moisture is present in the lines and a small or large amount of Isocyanates. The system must be flushed correctly to avoid any issues.

• During flushing, make sure the heaters on the machine are turned off.
• Flush at room temperature via pump circulation of your spray foam equipment (hoses, proportioner, guns, pumps, etc.).
• Use NZD ISO FLUSH Isocyanate Cleaner and Neutralizer (Liquid Iso Part A) to flush out minimum hardened Iso.

• Appearance: Clear liquid, Colorless to slight amber
• Odor: Slight Characteristic
• Ideal Operating Temp: Room Temperature
• Concentration: Full Strength
• pH 50%: 6.5 - 7.5
• Freezing Point: -70 °C (-94 °F)
• Flash Point: 116 - 120 °C (241 - 248 °F)
• Vapor Pressure (components): ≤ 0.02 mmHg 20 °C (68 °F)
• Vapor Density: 1.2 - 7.5 20 °C (68 °F) (Air = 1.0)
• Specific Gravity: 1.090 - 1.095 20 °C (68 °F) (Reference: water = 1)
• Components Boiling Point 760 mmHg: 242 - 255 °C (467.6 - 491 °F)
• Solubility in water: Soluble
• VOC: Exempt
• Recycling Parameters (Vacuum Distillation): 195 - 253 °F 760 mmHg Pressure
• Weight: 1 Gal
• HMIS Rating:
  • Health = 1
  • Fire = 1
  • Reactivity = 0