RAMSET® I-F CONTINUOUS-INSULATION FASTENING SYSTEM
A Safer Installation Process
Don’t risk injury with stick-pin solutions, the Ramset-I-F solution does not require installers to push insulation onto the sharp nail points of a pin.
Unlike powder-based solutions, the Ramset-I-F solution does not impact the installer’s wrist, elbow, and shoulder with the same amount of “kick-back force.” It also does not generate job-site debris in the form of used load casings.
Contrary to screw-and-plate solutions, which expose installers’ wrists and elbows to the rotational piece of the installation driver, the Ramset-I-F solution installs with a straight-push-down force.
Improved Performance of Installed Insulation
Stick-pin or screw-and-plate solutions interrupt insulation by impaling it with a piece of metal and creating a thermal bridge, but the Ramset-I-F solution installs an air gap between the building substrate and the un-insulated environment.
An Efficient Installation Process
The Ramset-I-F solution installs insulation fasteners in a single step completed in just seconds. This simplicity can cut labor time in half or more.
The Ramset-I-F solution does not require installer licensing or reloading of the charge after every fastener.
Unlike screw-and-plate solutions, the Ramset-I-F solution does not require drilling and tapping time. Instead, each fastener installs in seconds with the pull of a trigger.
Ramset is a registered trademark of Illinois Tool Works Corporation. All rights are reserved in the United States and in other countries.
Related Products
13 GAUGE TENSION WIRE
BOSS® 180 MULTI-SEAL
HANGERS
